|
We
Service all kinds of Pianos in all Cities of the Phoenix Metro Area
including all outlying areas such as:
Casa
Grande, Eloy, Maricopa, Queen Creek, Gold Canyon, Apache Junction, Rio
Verde, Cave Creek, New River, Anthem, Wickenburg, Buckeye, and any other
areas.
Contact
by Email
HolmanPianoService@cox.net
Home
Phone Number (602) 278-7805
Cell
Phone Number (602) 617-9464
Questions to Ask
The
Back
When you begin your inspection of a piano, look at the back. there will be
five or six vertical posts that serve as stays against the frame, giving
added strength to resist the tremendous pull of the strings inside. The
posts should be heavy and strong enough to provide adequate support in
proportion to the rest of the piano.
Soundboard
Next, ask about the soundboard, a wooden board at the back that translates
the vibrations of the strings into the "tone" of the piano. The soundboard
is one of the vital parts of the piano, and is is made of spruce in many
top-quality instruments. The fine, straight grain in spruce is ideal for
conducting sound.
The ribs on the back of the soundboard should run from one edge of the
soundboard to the other for support.
The
Plate and Bridges
The plate is an irregularly-shaped piece of cast iron bolted to the back of
the frame. It holds one end of the piano strings, and anchors most of the 20
tons of pull exerted by the taut strings.
The treble and bass bridges are another of the piano's vital organs. These
long pieces of hard maple are attached to the soundboard, transferring the
vibrations of the string to it.
Strung Back
When piano dealers refer to the strung back, they mean the parts just discussed plus the strings, which are made of high-grade steel drawn to
exact sizes. The bass strings are wound with wire to add weight and reduce
the frequency at which the string vibrates. This allows the use of
relatively shorter string to produce deeper notes.
Plate
At the top of the plate, the strings are wound through and around tuning
pins. These are set into the pin block, constructed of layers of carefully
seasoned hard wood which grips the pins in place for tuning stability.
Action
The working section of the piano is called the action. There are about 7,500
parts here, all playing a role in sending the hammers against the strings
when keys are struck.Grand pianos all have horizontal action, and upright pianos have vertical
action. There are two kinds of vertical action,direct-blow, which pushes
the mechanism that controls the hammer, found in taller pianos; and indirect-blow or drop action, which pulls the mechanism in lower
silhouette instruments.
Hammers
no hammers are formed of one or two layers of felt forged onto the wooden
hammer molding under tremendous pressure. If a dealer talks to you about a
9-pound hammer as opposed to a 12-pound hammer, he means the weight of the
sheets of felt that were used to make the hammers.
Tuning, Regulation
By the time you see the piano in the showroom, it has been tuned at the
factory several times, starting with the chip or rough tuning before the
mechanism is even locked into the cabinet. The last fine adjustment, called
voicing, includes the regulation of the hammer felts for individual notes.
Keys
Now, you can take your head out of the inside of the piano, and consider the
externals again. The piano keys rest in the key bed, a perfectly flat well in the front of
the cabinet that keeps the keys level. Each key is balanced by a center pin,
and bushed with fine wool for silence and proper clearance. The ivories
are not ivory anymore, but a fine molded plastic that won't crack or turn
yellow. The black keys are made of a similar material.
Pedals
Most pianos have three pedals, but most pianists need only two. The
sustaining, or damper pedal on the right lifts the dampers (which in a
resting position prevent the strings from vibrating) away from the strings
so that the tone is sustained after the keys are released.
The pedal on the left, called una corda, mutes the tone by shortening
the distance the hammers travel or by shifting the action slightly so fewer
strings are hit. Many pianos have a third pedal for sustaining bass tones
only, On most grand pianos ansd some uprights, the third pedal is a
sostenuto, which sustains selected tones at the pianist's discretion.
Cabinet
Finally, there's the cabinet, that handsome piece of furniture that will
take a prominent place in your decor. Modern cabinets are made of core stock
overlaid with thin veneers of fine furniture wood. Many grains and finishes
are available and modern finishing techniques assure excellent appearance
and easy care for years.
Here are some pictures of problems to look for in used pianos, I will be
updating theses periodically and by no means are the only things that could be
wrong with a piano
This Piano Has a cracked or separated rim.
%20(Large)_small.jpg) _small.jpg)
These Pianos have cracked plates
 
This Piano is a Bird Cage Piano and most likely can't be
tuned.  
This Piano has a cracked soundboard
_small.jpg)
This Piano not only has cracked soundboard but problems
with the bridge also. 
This Piano has a cracked pinblock
 |
.